Dimensions of Steel Pipes ASME B36.10 & B36.19 suffix (S)


 
6 to 14Other Dimensions:
1/2-2|2½-5|6-14|16-24
NPS68101214
OD168.3219273323.9355.6
 Wall Thickness
Sch 52.772.773.403.963.96
Sch 5S2.772.773.403.963.96
Sch 103.403.764.194.576.35
Sch 10S3.403.764.194.574.78
Sch 20...6.356.356.357.92
Sch 30...7.047.808.389.53
STD7.118.189.279.539.53
Sch 407.118.189.2710.3111.13
Sch 40S7.118.189.279.539.53
Sch 60...10.3112.7014.2715.06
XS10.9712.7012.7012.7012.70
Sch 8010.9712.7015.0917.4819.05
Sch 80S10.9712.7012.7012.7012.70
Sch 100...15.0918.2621.4423.83
Sch 12014.2718.2621.4425.4027.79
Sch 140...20.6225.4028.5831.75
XXS21.9522.2325.4025.40...
Sch 16018.2623.0128.5833.3235.71
 Wall Thickness
OD168.3219273323.9355.6
NPS68101214
6 to 14Other Dimensions:
1/2-2|2½-5|6-14|16-24

NPS = Nominal Pipe Size O.D. = Outside Diameter
Dimensions are in millimeters unless otherwise indicated.

 

 

DIMENSIONAL TOLERANCES FOR SEAMLESS AND WELDED PIPES ASTM A530

Nominal pipe size

up to 4 = ± 0.79 mm | 5 thru 8 = + 1.58 mm / - 0.79 mm

10 thru 18 = + 2.37 mm / - 0.79 mm | 20 thru 24 = + 3.18 mm / - 0.79 mm

Wall Thickness

All Diameters = - 12.5%

+ tolerance not specified

Length

+ 6.40 mm / - 0 mm

Weight

Weight = + 10% / - 1.5%

 

 

DIMENSIONS AND DIMENSIONAL TOLERANCES

UNITS OF MEASURE

American pipe standards use imperial and metric (SI) units for measurement. It is important not to combine the use of these units since rounding of dimensions has resulted in an incompatibility between some values.

DIMENSIONS

Standard dimensions for welded and seamless wrought steel pipe for high or low temperatures and pressures are described in ASME B36.10. Standard dimensions for welded and seamless wrought stainless steel pipe are described in ASME B36.19. The suffix "S" in the Schedule Number is used to differentiate B36.19 pipe from B36.10 pipe. ASME B36.10 includes other pipe thicknesses which are also commercially available with stainless steel material.

DIMENSIONAL TOLERANCES

The basic permissible variations, including pipe length and straightness requirements, are defined in ASTM A530, this standard being referenced by all ASTM pipe standards.